What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 30.06.2025 11:28
[old diagram got deleted by accident]
Now when you have a certain ac resistance, then a current flows in a loop.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
He then describes Rainy Season and Lightning.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
There are three different concepts here that are getting confused.
2024–10–10[John johnson John Johnson ]
This device then solves the entire problem.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
What is your experience about Bonamour Sleep Earbuds?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
One
but this device (an Inductor) … impedes the rapid changes in the current.
What does a fuse do?
It also is a device that limits the change in current flow.
At least they know the answer if they wanted it.
Suspect in ‘King of the Hill’ actor’s death ‘immediately’ confessed: police - KTLA
Barnstars:
This one hit behind the barn.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Space Force demos rapid turnaround on latest GPS III launch - Defense News
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
First Sentence:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
I always feel very tired after I do some exercises, even after a night's sleep. What's the problem?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
NASA’s Voyager Probes Uncover a Mysterious “Wall of Fire” Beyond Our Solar System - The Daily Galaxy
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is where this question deviates from being a 'generic' question, and becomes more specific.
The third is lightning and “how it gets conducted into a home.”
[image of Common-mode choke]
This May Be the Right Time to Raid Your Silver Drawer - Newser
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
nine
These devices are installed between the “hot” and “neutral” and protective ground.
This is 'the assistant's answer'
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
He then asserts :
It seems Mohan does not understand the difference between a comment and an Answer.
Upvotes:
eight
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
a photo is worth a thousand words.
He then describes the function of a fuse.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
One is “what exactly is in a ‘surge protector’ ? ”
A circuit breaker is similar, but is resettable.
At one ohm, the resistor has a maximum of 1 watt power.
So, the voltage could go up to 500 volts, and the fuse will not open up.
An AC voltage/ current source, and an ac inductive load.
For this case there are devices called Metal oxide varistors (MOV).
The other is “what does a “fuse” do?”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
(Dc diagram shown, AC is similar).
A fuse is a non-resetable over current circuit protector.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These are simplified answers to the original question, and does not change anything I wrote above.
This is where the MOV conducts again, and dissipated the energy.
2024–10–16 [ OO OLAOYE OYEBODE ]
Here is a simplified AC power diagram.
But… the neutral is now “floating” because of the 1 ohm resistance.
The MOV will conduct when the voltage exceeds 50% of line voltage.
There are two important concepts here.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
In schematic diagrams this is the symbol for a fuse:
I post the exact comment here.
so, what happens?
what exactly is a ‘surge’ protector?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
but I think this circuit , shows a few more pieces.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The bolt then partially travels down the line to your home.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–14 [Omar Gharbi Omar Gharbi ]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Edit 2024–10.
But it can get overloaded, and no longer works.
What is lightning?
the problem then depends on "how fast does the fuse operate?".